FANDOM


Sense spray-naked3

Glade Sense & Spray.

Clean linen sense spray 360

Glade Sense & Spray. (With 360° design).

8333320

A Glade Sense & Spray refill.

Section headingEdit

Shouldn't it be nice to be noticed? The Glade Sense & Spray Automatic Freshener, and Glade Sense & Spray Automatic Freshener (with 360° design) detects motion when you pass by, instantly releasing a burst of fragrance into the air. Equipped with motion sensor technology, it cuts down on waste and conserves refills by automatically freshening only when you need it the most.

BenefitsEdit

Glade Sense & Spray Automatic Freshener and Glade Sense & Spray Automatic Freshener (with 360° design) offer a unique fragrance experience that blends attractive design with motion-sensor technology that allows the unit to spray when you pass by, automatically releasing a concentrated burst of fragrance into the air. The units also come with a boost button, that could be pressed at any time for an extra burst of fragrance whenever you like it or need it. Choose from a variety of quality Glade fragrances. (4 scents available).

Sense & Spray instructionsEdit

  • Operation

The unit automatically sprays a burst of fragrance when a shadow has been cast upon a sensor. To conserve the refill, the unit comes with a lock-out mode setting. The lock-out mode for Sense & Spray is generally 20 minutes (Or 30 minutes if you have an older Sense & Spray unit from 2008-2010). The lock-out mode for Sense & Spray (with 360° design) is 15, 20, or 30 minutes depending on the switch setting chosen inside. For an instant burst of Glade fragrance anytime, press the boost button on the front/top of the unit. Use only Glade Sense & Spray refills in this unit. (See picture to the right).

  • Placement

For best results, place unit upright on a flat surface where upward spray will not be obstructed. Place unit within 5 feet of traffic flow.

  • Helpful hints
    • The sensor may not respond if:
      • The room is too dark. Ensure there's sufficient lighting to allow a shadow to be cast upon sensor.
      • The unit is placed directly on or in a light source, especially sunlight. Move the unit out of the bright light.
      • Sensor on the front of the device is blocked by objects. Position the unit so that the sensor is unobstructed.